Skip to content
Glossary November 2026 6 min read

What Is VoIP? Voice over IP Explained

VoIP (Voice over IP) carries phone calls as data packets over IP networks instead of copper circuits. How it works, SIP and RTP, and what shapes call quality.

D
November 2026

Quick answer

VoIP (Voice over Internet Protocol) is the transmission of speech across data-style networks. The voice is turned into small packets, sent over an IP network and played back at the other end. A signalling protocol such as SIP sets the call up, and a media protocol such as RTP carries the audio.

A traditional phone call reserves a circuit for the whole conversation. A VoIP call does not reserve anything: the voice is cut into short pieces, each piece travels as a packet, and the far end puts them back in order. That one change is why the same network can carry phone calls, video and data, and why contact centres can run agents from anywhere with a good connection.

What is VoIP?

NIST, in its guidance on securing VoIP systems, describes Voice over Internet Protocol as the transmission of speech across data-style networks. Everyday use of the word is wider: people say VoIP for the technology, for the service that sells it, and for the calls made with it. In all three cases the voice travels as IP packets.

VoIP is not one protocol. It is a family of them working together. The two you meet most often are SIP, which handles signalling, and RTP, which carries the audio. The SIP and RTP entries cover each in detail.

How does a VoIP call work?

Signalling and media are separate. The signalling decides who is calling whom and how; the media is the voice itself.

  1. The caller dials. The phone, softphone or dialer sends a SIP request that names the destination.
  2. The call is routed. SIP servers and gateways pass the request along until it reaches the called party, or a carrier that can reach their number.
  3. The two sides agree on how to talk. They exchange the codec and the network addresses and ports each will use for audio.
  4. Audio flows as RTP packets. Each side encodes speech with a voice codec and sends it in a steady stream of short packets, in both directions at once.
  5. Either side hangs up. A SIP message ends the session and the audio stops.

RFC 3261 describes SIP as an application-layer control protocol for creating, modifying and terminating sessions with one or more participants, including Internet telephone calls. RFC 3550 describes RTP as providing end-to-end delivery for real-time data such as audio, with payload type identification, sequence numbering, timestamping and delivery monitoring. RTP does not itself guarantee timely delivery or quality of service, which is why the network matters (see below).

When the other party is on an ordinary phone number, the call also crosses a gateway to the public phone network. The PSTN entry explains that step, and the SIP trunk entry explains the service that provides it.

How is VoIP different from a traditional phone line?

Traditional circuit-switched lineVoIP
How voice travelsOver a circuit set up for the callAs packets over an IP network
SignallingTelephone-network signallingUsually SIP
AudioCarried inside the circuitUsually RTP, encoded by a codec
Where the user can beTied to the line or siteAnywhere with a suitable network connection
What affects qualityThe circuitThe network path: delay, jitter and packet loss
Extra featuresAdded in the telephone networkHandled by software such as a PBX or dialer

Is VoIP the same as SIP?

No. VoIP is the whole idea of voice over IP. SIP is one protocol used to set up VoIP calls, and it is the one a SIP trunk uses to connect a business phone system or dialer to a carrier. Browser phones often use WebRTC for media, as the WebRTC softphone entry explains.

What affects VoIP call quality?

Because the voice shares a network with other traffic, four things shape what the listener hears:

  • Latency. How long the audio takes to arrive. High delay makes people talk over each other. See latency in VoIP.
  • Jitter. How much that delay varies from packet to packet, heard as choppy speech. See jitter.
  • Packet loss. Packets that never arrive, heard as gaps.
  • Codec. The compression used to encode speech, which trades audio quality against bandwidth.

The guide on how to measure VoIP call quality shows how teams track these per call.

How do contact centres use VoIP?

A contact centre uses VoIP to place and receive calls without a bank of physical lines. Agents connect through a softphone in the browser or a SIP phone, a dialer places the calls, and a carrier link carries them to the phone network. Supervisors can listen in, record and report on calls because the voice is already software-visible data.

How does DialerBee use VoIP?

DialerBee is a cloud contact centre platform, so calls run over VoIP. A self-serve company connects its own SIP trunk or its own PBX, and the carrier bills the minutes (bring your own carrier). The BYOC page lists what to gather from a carrier and how the connection is set up. Calling starts once that line is connected and approved.

Frequently Asked Questions

What does VoIP stand for?

VoIP stands for Voice over Internet Protocol, often written Voice over IP. It means carrying voice calls as packets over an IP network.

Is VoIP the same as SIP?

No. VoIP is the general approach. SIP is a signalling protocol used to set up many VoIP calls. The audio itself is usually carried by RTP.

Does VoIP need the internet?

VoIP needs an IP network. That can be the public internet, a private network or a carrier's managed network. Quality depends on delay, jitter and packet loss on whichever path is used.

Can a VoIP call reach an ordinary phone number?

Yes. A gateway connects the IP side to the public phone network, which is what a SIP trunk provides.

What makes VoIP calls sound bad?

Mostly the network path: high latency, jitter and packet loss. The codec and the endpoint device also play a part.

Sources

Related reading: SIP · RTP · SIP trunk · Voice codec · Jitter · Latency in VoIP · Bring your own carrier · How to measure VoIP call quality

Related reading: What Is a PBX? Private Branch Exchange

Related terms

Ready to see DialerBee in action?

Request a 15-minute live demo, or start a 14-day free trial — no slides, no commitment. Calling starts once your own SIP trunk or PBX is connected and approved.

14-day free trial · free AI credit · no card · 11 languages · BYOC · compliance-supporting controls